The driver alert system is designed to aid you. It is not intended to replace your attention and judgment. You are still responsible to drive with due care and attention.
Note: The system will store the on/off setting in the information display menu through ignition cycles.
Note: If enabled in the menu, the system will be active above 40 mph (64 km/h). When below the activation speed the driver alert system will inform you the system is unavailable.
Note: The system works as long as one lane marking can be detected by the camera.
Note: If the camera is blocked or if the windshield is damaged, the system may not function.
Note: The system may not be available in poor weather or other low visibility conditions.
The system automatically monitors your driving behavior using various inputs including the front camera sensor.
If the system detects that your driving alertness is reduced below a certain threshold, the system will alert you using a chime and a message in the cluster display
Switching the System On and Off
You may switch the system on or off through the Information Display.
Refer to the Information Displays chapter. The system on or off setting is stored and will use your last setting the next time the vehicle is started.
Note: The system will not issue warnings below approximately 40 mph (64 km/h).
The warning system is in two stages. At first the system issues a temporary warning that you need to take a rest. This message will only appear for a short time. If the system detects further reduction in driving alertness, another warning may be issued which will remain in the information display for a longer time. Press OK on the steering wheel control to clear the warning.
When active the system will run automatically in the background and only issue warning if required. You can view the status at any time using the information display. Refer to the Information Displays chapter.
The alertness level is shown by six steps in a colored bar.
The current assessment of your alertness is within a typical range.
The current assessment of your alertness indicates that you should rest as soon as safely possible.
The status bar will travel from left to right as the calculated alertness level decreases. As the rest icon is approached the color turns from green to yellow to red. The yellow position represents the first warning is active and the red position represents the second warning is active.
Note: If you have recently received a warning; you should consider resting, even if the current assessment is with the typical range.
Note: The alertness level will be shown in grey if the camera sensor cannot track the road lane markings or if the vehicle speed drops below approximately 40 mph (64 km/h).
Resetting the System
You can reset the system by either: • Switching the ignition off and on.
• Stopping the vehicle and then opening and closing the driver’s door.
Information About Uniform Tire Quality Grading Tire Quality Grades apply to new pneumatic passenger car tires. The Tire Quality Grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: • Treadwear 200 Traction AA Temperature A ...
General operating tips
Manual Climate Control • To reduce fog build-up on the windshield during humid weather, select Defrost. You can also improve clearing by increasing the temperature and fan speed. • To reduce humidity build-up inside the vehicle, do not drive with the system off or with recirculated air engage ...
PRINCIPLES OF OPERATION WARNING: Never let a passenger hold a child on his or her lap while your vehicle is moving. The passenger cannot protect the child from injury in a crash. WARNING: It is extremely dangerous to ride in a cargo area, inside or outside of a vehicle. In a crash, people ridin ...